Skip to content
IUVBoots
Cowboy Boots For Women Mid Calf Cowgirl Boots Embroidered Pull-On

Cowboy Boots For Women Mid Calf Cowgirl Boots Embroidered Pull-On

White

$46.54 to $48.99 4.5

White mid calf western boots built with a classic snip toe, shaft embroidery, and a steady two inch low heel for daily wear.

Sizes we cut this pair in. Each one is listed separately:

White synthetic uppers give this mid calf pair a clean look right out of the box. We shaped the front with a traditional snip toe, narrowed toward the tip and squared off flat at the front. The shaft rises partway up the lower leg, finished with tonal western stitch lines.

On the bench

Snip toe profile

We lasted the front to taper down the foot before finishing with a clipped flat edge. It creates a defined western outline without squeezing the sides of the forefoot as the material breaks in.

Two inch heel

The low block heel sits square under the back of the foot for solid balance. It gives you a modest lift while keeping your stance flat and planted on hard ground across a long day.

Mid calf height

The shaft finishes midway up the leg with a gentle curve at the top collar. Dual side pull tabs sit flush against the opening so you can pull the boot on quickly without catching the soft synthetic interior lining.

Sizing notes

Our size run spans whole and half sizes from 5 through 10. Check the size chart before choosing your standard shoe size, as the tapered snip toe requires enough room for the toes to rest flat.

Size chart

This pair, size by size
Brand SizeUS SizeUK SizeEuropeShoe Width (in)
554373.2
5.55.54.537.53.2
665383.2
6.56.55.538.53.3
776393.3
7.57.56.539.53.4
887403.5
8.58.57.540.53.5
998413.5
9.59.58.541.53.6
10109423.6
10.510.59.542.53.6
111110433.7
11.511.510.543.53.7

Getting the size right

The chart above does not include an inside length, but our women's charts agree with each other closely enough that the grid on the fit bench answers for it. Measure heel to longest toe and read the number there.

Read a measurement against our grid